A board-mounted DC-link option
The plastic housing and lead choices give the mechanical team a clear starting point for the PCB interface. Specify the body envelope, lead pitch and lead diameter required by your assembly rather than relying on the series photograph. The resin filling is described with a UL94 V-0 material rating.
For a housing comparison, the MKP-LM THB version explicitly specifies PPS. The ordinary MKP-LM description specifies a plastic shell without naming PPS. Identify any controlled housing-material requirement on the enquiry instead of assuming that the two versions have identical construction.
Ratings and temperature conditions
The rated voltages at 85°C are 500, 600, 800, 900, 1,000, 1,100 and 1,200 VDC. Tolerance choices are J (±5%) and K (±10%). Select one required voltage-capacitance combination and request its electrical data and drawing. The range endpoints do not constitute a complete configuration matrix.
The case-temperature specification runs from −40°C to +105°C. Between 85°C and 105°C, the operating-voltage derating is 1.33% per degree relative to rated voltage at 85°C. The catalogue life statement is 50,000 hours at rated voltage and 85°C. Retain these conditions when comparing the part with the thermal requirements of the equipment.
Humidity and insulation tests
The ordinary MKP-LM specification includes a biased humidity test: 1,000 hours at 85°C and 85% relative humidity with rated voltage applied. It gives an absolute capacitance-change limit of 10% and insulation resistance of at least 50% of the initial limit. Humidity testing is therefore not described only for the THB-labelled product.
The terminal-to-terminal DC test is 1.5 times rated voltage for 10 seconds. The terminal-to-case test is 2,100 VAC at 50 Hz for 10 seconds. These short-duration electrical tests and the humidity exposure describe different requirements; they should not be merged into a single operating-voltage claim.
The specified climatic category is 40/105/56. If an equipment requirement calls for a particular environmental evaluation, send the procedure and ask for documentation identifying the configuration covered, rather than relying only on the category designation.

Example for an initial PCB layout
For a 500 VDC, 22-microfarad configuration, the table gives a width of 32.0 mm, height of 36.5 mm and thickness of 22.0 mm, each with a ±1 mm tolerance. The lead pitch is 27.5 ±0.5 mm and lead diameter is 1.0 ±0.05 mm.
That same row lists ESR of 5.0 milliohms at 10 kHz and RMS current of 10.0 A at 85°C and 10 kHz. These values belong to this specific example. For another rating or lead arrangement, request the applicable row and drawing before committing the board layout.
Send the circuit and footprint together
Use the DC-link capacitor range to compare related families. For an MKP-LM quotation, provide capacitance, tolerance, bus-voltage conditions, current waveform and local temperature, together with the mounting drawing.
Our capacitor RFQ checklist can help organize a prototype or production enquiry. Identify any required humidity qualification and include the desired sample quantity separately from production demand. Request a clearly identified configuration with its electrical and mechanical documents.
Frequently asked questions
Does ordinary MKP-LM have published humidity test data?
Yes. Its specification lists 1,000 hours at 85°C and 85% relative humidity with rated voltage applied, together with acceptance criteria.
Is the ordinary case described as PPS?
The MKP-LM page specifies a plastic shell. PPS is explicitly named on the separate MKP-LM THB page.
Can I operate at full rated voltage throughout the temperature range?
The specification requires voltage derating above 85°C, at 1.33% per degree up to 105°C relative to the rating at 85°C.
Sources & technical reading
Product information is based on the SMILER catalogue. Confirm the specification for the selected configuration.



